How to Use Snare Wire

Snare Wire
Reading Time: 3 minutes

How to Use Snare Wire

A snare wire for drummers

Snaring is a form of trap made up of a noose and designed to catch animals. Using a strong string, it usually holds the animal’s body or neck. This string is usually a snare wire. This is regarded as one of the most effective and cost-effective methods of capturing animals.


Constructing a Trap: A Step-by-Step Guide

Step-1: Place the Snare Cable and the First Ferrule

Prepare the cable that best meets your requirements. We’re mostly concerned with the length, which can range from 3 to 8 feet depending on the type of trap you’re attempting to set.

It’s time to secure the cable after it’s been prepped. The curled end of the cable will serve as the anchor point, so look for it. Install the ferrule, also known as the end stop, now along the cable’s end.

Step 2: Install the Washer

You’ll need to secure the washer to the cable’s unattached end in this step. Check to see if it fits through the attached ferrule. In the following steps, it’s vital to secure the swivel head.

Step-3: Fix the snare swivel head

Place the swivel inside the cable after securing the open end of the cable into the swivel’s barrel aperture.

Step 4: Put the Twist Lock Back in Place

After we’ve finished with the swivel head, we’ll drop the twist lock, also known as the snare support collar, through the cable’s open end. Ensure the cable is enclosed near the swivel head with the broader part.

The collars should then be pushed to the side and out of the way towards the next end.

Step 5: Adjust the Micro Lock on the Snare Drum

Secure the open portion of the cable with the snare’s tiny lock. The long end of the lock must be facing the open end in this situation.

Step-6: Develop the Shepherds Cane 

This is the most difficult of all the steps mentioned so far. You’ll learn the technique of settling the micro lock. It closes swiftly enough to grasp the animal if you pay close attention and determination. Let’s see what we can do about that!

  • Let the cable lay naturally

Because the snare drum is normally in a spool, it is easier to drop because it has a natural curve. To avoid injury, keep your grasp flexible while creating the Shepherds Cane.

  • Use either your left or right hand to grasp the cable

Use needle-nose pliers to curl the snare if it doesn’t coil naturally off the spool. Hold the cable in the hand that is most comfortable for you, but make sure the cable is facing you. Also, remember to grip the cable’s end with your thumb.

With pliers, detach the frayed end of the cable and tap holes with nails for a more successful cable launch. You can also drill a pilot hole to improve the effectiveness.

  • Setting the ultimate end stop

Before you launch, make sure your long-range shot’s 90-degree end is correct. As a final step, pound the ferrule into the cable once it’s been achieved.
Check out the 6 Best Snare Wires For Versatile Drummers


A snare trap is one of the most practical ways to catch animals in the wild. Other materials for making a snare drum could be suggested. However, you must realize that animals’ incapacity to chew through the metal wire is what made this material effective in this process!

You can also read: How To Use Ambient Sound On Headphones

You Might Also Like

Leave a Reply